Sylvania ToLEDo Ultra Output Platinum T8 G13 12W 1200mm – replaces 36W, 100k h

Dual compatibility — CCG and AC

This lamp operates in two different ways, which adds flexibility to the installation:

Installation method 1: CCG (magnetic ballast)

• Suitable for older fluorescent luminaires with a magnetic ballast
• The starter must be replaced with an LED-compatible one (short-circuit S-starter)
• The magnetic ballast remains unchanged
• Direct replacement for the fluorescent tube as a single lamp replacement

Installation method 2: AC (direct mains voltage)

• Suitable for new LED luminaires or renovations
• Ballast and starter are removed — wiring modification required
• The lamp is connected directly to 230V mains voltage
• Requires installation work by an electrician

Explore our selection in the Electrical supplies → Control gear/Ballasts category.

1200 mm length — 36W T8 fluorescent tube standard

This is a standard-sized 36W T8 fluorescent tube replacement, most commonly used in:

• Offices — general lighting in open-plan offices, corridors, meeting rooms
• Supermarkets and department stores — retail lighting in aisles and shelf spaces
• Railway stations and service stations — general indoor lighting
• Parking areas and car parks — long-lasting lighting
• Industrial facilities and warehouses — general lighting
• Hospitals and healthcare facilities — reliable lighting with long operating hours

Energy savings and total costs

12W LED produces the same luminous efficacy as a 36W fluorescent tube, but with significantly lower energy consumption:

• 36W T8 fluorescent tube: lifespan 12,000–24,000 h, requires several replacements over the years
• This 12W LED: lifespan 100,000 h — 4–8 times longer, no replacements
• Energy savings: approximately 67% (12W vs 36W)
• Lower heat generation — also reduces ventilation costs in hot environments

Glass tube structure — omnidirectional light distribution

The glass tube structure produces a 360° omnidirectional light distribution like a traditional T8 fluorescent tube. This differs from many LED tubes where light is directed in only one direction — more even light distribution in the space, fewer shadows, suitable for reflector luminaires where light is distributed to the edges of the luminaire.

EU EcoDesign restrictions — fluorescent tube ban

The EU EcoDesign directive 2019/2020 restricts the sale of T8 fluorescent tubes for new systems from 25.8.2023. This LED alternative is fully compliant with EU regulations, a direct replacement for fluorescent tubes with CCG installation method, and a long-term solution — the 100,000-hour lifespan makes it a future-proof choice.

Installation checklist

CCG installation (magnetic ballast):

1. Check that the luminaire has a T8 G13 base and contains a magnetic ballast
2. Turn off the power at the main switch
3. Remove the old fluorescent tube
4. Replace the old starter with an LED-compatible one
5. Install the new LED tube in the same holder
6. Turn on the power and check operation

AC installation (direct 230V):

1. Electrician available — requires wiring modification
2. Turn off the power at the main switch
3. Electrician removes the ballast and starter
4. Wired directly to 230V mains voltage
5. Install the LED tube in place
6. Turn on the power and check operation

Also explore our selection of other T8 LED tubes.